Brake Light Switch Installation
Brake Light Switch Installation,
Brake Light Switch Installation,Typically, the brake light switch is connected electronically to the fuse panel, which automatically sends power to the brake light portion of the taillight through the taillight wire. However, it is conceivable that some lighting setups may require Removing Disconnect connector from Brake Light Switch F. Remove Brake Light Switch F by turning 45 ° to left. Installing and adjusting To ensure secure installation, brake light switch F must NOT be reused after removal CAUTION: As the stock setup incorporates the brake light switch, this part of the project is more complicated. With a 4mm Allen key, remove the plastic heel This will be quite tight, as it is installed to 18 Nm (13.0 ftlb). Now remove the footpeg mounting BRAKES Mechanical.Components Brake System Removing Remove brake light switch. Refer to BRAKE LIGHT SWITCH. Disconnect Installing Installation is performed in reverse sequence. Note the following: Clip brake pedal with Check for proper connection of each switch circuit terminal to ECM connector. 3. If connections are OK, check brake light switch circuit for the following. ○ Resistance of each "YEL/GRN" wire terminal and "GRN/YEL" wire terminal (N32A model Unplug the wire harness at the connector from the switch. —The locking tab must be lifted before the connector can be removed. 3. Remove the hairpin retainer and white nylon washer. Slide the brake light switch and the pushrod away from 2. Remove the left.sound insulator. 3. Disconnect the wiring from the switch. 4. Pull the switch out of the retainer in the bracket. To install: 5. Install the retainer in the bracket, at the underside of the bracket. 6. Depress the brake pedal and '•The brake light switch is almost always the first place to look for the cause of the brake lights flickering over bumps or Remove the brake pedal assembly. To install: 7. Install the brake pedal assembly to the vehicle in the correct position. 8.1 6 Readjust the brake light switch so it's actuated when the pedal is up (not depressed) (refer to Section 14). 14.1 Brake light switch installation details Brake light switch removal, installation and adjustment Refer to illustration 14.1 The.electrical connections for these switches are shown in Fig. 47. On 1981 and later U.S. built Rabbits and Pickup Trucks the brake warning light switch is also hydraulically operated, but it is located on the brake proportioning valve.