Remove And Replace Heater Core
Remove And Replace Heater Core,
Remove And Replace Heater Core,Take care not to damage the fins of the heater core when removing and replacing it. Control Valve The control valve is a cable, vacuum, or electricallyoperated shutoff valve used at the inlet of the heater core to regulate coolant flow through The large A/C case requires removal of the fender in order to remove the exterior case. Therefore, in order to replace the heater core, you have to remove the case. That makes replacing the heater core on an A/C car a huge job. Before Installing a new heater core is the reverse of removing the old one. Therefore, you'll still have to take the dash apart to replace your core. From this you can see that replacing something as simple as a lousy heater core isn't easy. To quote If the.radiator is damaged, advise your supervisor so a decision can be made about whether to repair it or replace it. Removing, Inspecting, and Reinstalling the Heater Core S09013 Removing, inspecting and Removal of a heater core may Heater module mounting, 88. Others similar 2. Remove the blower motor retaining screws and remove the motor. 3. To replace, reverse the removal procedure. Use sealer as needed to make a watertight seal. Heater Core REMOVAL AND Remove the blower impeller retaining nut and separate the motor from the impeller. 8. To replace, reverse the removal procedure. HEATER CORE REMOVAL AND INSTALLATION— NON AIRCONDITIONED CARS 197677 LeMans 1 .Remove the screws attaching the blower case to the heater case. Remove.the heater core shroud screws and remove the shroud and core. 1977 CUTLASS BLOWER MOTOR l. Remove the right front fender filler panel. 2. Disconnect the Unfasten the blower motor mounting screws, remove the motor and disconnect its wiring. 7. Installation is the reverse of removal. 197576 88 Heater Core Removal and Installation with Air Conditioning 1973 88 AND 98 1 . Disconnect the Remove the retaining screws and remove the motor. Use sealer as needed upon installation for a watertight seal. 88 and 98 Heater Core 1. Disconnect the negative battery cable, the blower motor wiring and the heater core ground strap. 2.Remove the retaining screws and remove the motor. Use sealer as needed upon installation for a watertight seal..88 and 98 Heater Core 1 . Disconnect the negative battery cable, the blower motor wiring and the heater core ground strap. 2.